MIL-DTL-43719D
4.4 Conformance inspection. Unless otherwise specified, sampling for inspection shall be
performed in accordance with ASQ Z1.4.
4.4.1 Component and material inspection. In accordance with 4.1, components and materials shall
be inspected in accordance with all the requirements of referenced documents unless otherwise excluded,
amended, modified, or qualified in this specification or applicable purchase document.
4.4.2
End item inspection.
4.4.2.1 End item visual examination. The marking material shall be examined for the defects listed
below. The sample unit shall be 1 yard, one sheet, one letter, one numeral, one kit, one legend or one symbol
marker, as applicable. The lot size shall be expressed in units of 1 yard, one sheet, one letter, one kit, one
numeral, one legend, or symbol, as applicable. When material is supplied in rolls or 10-unit packages, the
number of rolls or packages from which the sample units are to be selected shall be in accordance with table II.
The sample units shall be apportioned equally among the selected rolls or packages. The defects found shall
be counted, regardless of their proximity to each other, except where two or more defects represent a single
local condition of the material, in which case only the more serious defect shall be counted. In rolls, a
continuous defect shall be counted as one defect for each sample unit or fraction thereof in which it occurs.
The inspection level shall be level I and the acceptable quality limit (AQL) expressed in terms of defects per
hundred units, shall be 6.5.
Examine
Defect
Materials:
Backing
Not as specified
Not coated with adhesive as specified
Liner
Missing
Not smooth
Does not completely cover adhesive
Transfer sheet
Missing
(when applicable)
Not smooth
Does not completely cover face side
Not translucent
Not adhered
Appearance
Any blister, pit, or foreign matter
Any tear, cut, hole, crack, or crease
Edges ragged, nicked, crushed, or uneven
Not cut smooth; not cut as specified
Notches, punch holes, slits, etc. (as applicable) not as specified
Letters and numerals not centrally located in rectangles (as applicable)
Letters, numbers, legends, and symbols not as specified
Sticky edges; any solid lump
Spot, stain or streak more than 1 inch in its longest dimension 1/
1/ Clearly visible at normal inspection distance (approximately 3 feet).
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business